Much of the work I have done in innovation can be integrated into a single project.
- Lead acid battery stack with single large stack anode/cathode combination
- The turbine/antenna mast that can swing up, telescope, and then raise the e turbine as needed
- Also allows replacement of sail for sailing ops since turbine will always track to wind. For that use keep in mind to replace ballast with batteries.
- Permanent and portable systems as needed
- The turbine that rotates on all axis for when mast can not be level, or wind is sloping
- The lightweight round house can easily be mounted with the atv dry belt system, being effective for water, snow, tundra, muskeg, or most terrain less than about 40 degrees
- The horizontal telescoping platform integrates stability/hovercraft type lift when overloaded to give increased capacity when traversing water
- A paddlewheel configuration that provides motion while trapping air for hybrid hovercraft ops
- The integration of level adjustment as part of the adaptive platform system
- Full circumference hydronic tubing to in walls to keep dew point above interior air of the exterior wall system, and for heating in cold climate. Remember to have dehumidifying section
- Integrated emergency air supply as precaution if exposed to air contamination or fire
- New human power harness system could provide emergency power . Replace the standard crank shaft
- .Mini HRV for trailers or other smaller spaces where full size model is not cost and space effective
- Motor/Gen axles to lessen load on pulling vehicle as well as capture energy going down hills for help up, could also help positioning when on water or spun up to provide centrifugal stability in rough seas
- When stocking keep in mind center of gravity in case waterborne time is needed
- Provide DC energy storage for at least 5 days of full activity including climate conditioning